GE IC3600EPZU1 Power Supply Board

GE IC3600EPZU1 Power Supply Board

Part Number IC3600EPZU1 Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockIC3600EPZU1 is a Power Supply Board developed by GE. These were the first two Speedtronic gas/steam turbine management controllers. They're both meant to limit turbine output to within the unit's capabilities, sequence parameters during startup, provide a precautionary shutdown in the event of a non-recoverable system failure, and monitor and annunciate problems. It is designated EPZU separately from its board identification number and has the identifiers 006/01 and 002/01. One of the edges has a number. One fuse, four diodes, and two wire wound resistors make up the IC3600EPZU1. 2147902 10K 5% 10W and 2147901 1K 5% 10W are the model numbers. 

It has one polyester vinyl capacitor with the markings 2Q78 10F +/- 10%. Nine aluminum electrolytic capacitors are arranged in three lines of three. 30D + TE 1307 50F 50 VDC 105C + 9807H are the markings on these. There is also one metal oxide varistor on the board, which is labelled MOV1 and is located in the middle of the board. Varistors are voltage-dependent resistors with diode-like voltage-current properties. They are employed to safeguard electrical devices against high transient voltages, and when a strong current is produced owing to high voltage, they will short themselves out. On one edge of the IC3600EPZU1, there are twenty-five pins. These pins are linked together when the IC3600EPZU1 is installed into a Speedtronic frame, allowing the board to interface with the rest of the system.

Features 

▪ Contains 10 Mbytes of battery-backed user memory and 10 Mbytes of non-volatile flash user  memory. 

▪ Provides access to bulk memory via reference table %W. 

▪ Configurable data and program memory. 

▪ Programming in Ladder Diagram, C, Structured Text, and Function Block Diagram. 

▪ Supports auto-located Symbolic Variables that can use any amount of user memory. 

▪ Reference table sizes include 32Kbits for discrete %I and %Q and up to 32K words each for  analog %AI and %AQ. 

▪ Supports Series 90-70 discrete and analog I/O, communications, and other modules. For a  list of modules supported, refer to the PACSystems RX7i Installation Manual, GFK-2223. 

▪ Supports all VME modules supported by Series 90-70. 

▪ Supports RX7i data monitoring over the web. Allows a combined total of up to 16 web server  and FTP connections. 

▪ Supports up to 512 program blocks. Maximum size for a block is 128KB. 

▪ Test Edit mode allows you to easily test modifications to a running program. 

▪ Bit-in-word referencing. 

▪ Battery-backed calendar clock. 

▪ In-system upgradeable firmware. 

▪ Three isolated serial ports: an RS-485 serial port, an RS-232 serial port, and an RS-232  Ethernet station manager serial port. 

▪ The embedded Ethernet interface provides: 

 Data exchange using Ethernet Global Data (EGD) 

 TCP/IP communication services using SRTP 

 Support for SRTP Channels, Modbus/TCP Server, and Modbus/TCP Client 

 Full programming and configuration services 

 Comprehensive station management and diagnostic tools 

 Two full-duplex 10BaseT/100BaseT/TX (RJ-45 Connector) ports with an internal network  switch providing auto-negotiated network speed, duplex mode, and crossover detection. 

 User-configurable Redundant IP address 

 Time synchronization to SNTP time server on Ethernet network (when used with  Release 5.00 or later CPU module).

OTHER INFORMATION

• Available with either the 1.1 GHz, 1.6 GHz or 1.8 GHz  Pentium® M processor  

• 1.4 GHz Pentium M processor coming soon  

• Up to 2 Mbyte of advanced L2 cache  

• Up to 1.5 Gbyte DDR SDRAM  

• Up to 2 Gbyte bootable CompactFlash on secondary IDE (see  ordering options)  

• Internal SVGA and DVI controller  

• Serial ATA support through P2 rear I/O  

• 400 MHz system bus via Intel® 855GME chipset  

• Ethernet controller supporting 10BaseT and 100BaseTX  through the front panel  

• Gigabit Ethernet controller supporting 10BaseT, 100BaseTX  and 1000BaseT interface with optional VITA 31.1 support  

• Four asynchronous 16550 compatible serial ports  

• Four Universal Serial Bus (USB) Rev. 2.0 connections, two on  the front panel and two rear I/O  

• PMC expansion site (PCI-X, 66 MHz)  

• 32 Kbyte of nonvolatile SRAM  

• Operating system support for Windows® XP, Windows 2000,  VxWorks®, QNX® , LynxOS® and Linux