GE IC3600KVSA1 Zero Speed Relay Board

GE IC3600KVSA1 Zero Speed Relay Board

Part Number IC3600KVSA1 Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark VI/VIe Function Module Availability In StockGE Developed IC3600KVSA1 as Zero Speed Relay Board under Mark I or II series. General Electric's Speedtronic turbine management systems, Mark I and Mark II, are both available. They were designed to serve five main purposes. These functions include limiting the turbine maximum output to within the unit's capability, protecting the turbine in the case of a non-recoverable system failure inside the system, and controlling the turbine output power over its load range. For a startup, the turbine control settings and auxiliaries must be sequenced. 

Failures in the gas turbine, its auxiliaries, and the control system are monitored and reported. The IC3600KVSA1 is designed with a single-reed relay in the middle. Reed relays are fast, tiny, and lightweight devices that employ an electromagnet to control a reed switch. This is a GE reed relay with the following specifications: Coil 28 VDC, Cont. 50 VA, NP 68A99729P2. On the upper surface of the relay, there is a relay schematic. Multiple wires connect the relay to the line of pins on one edge of the board. There is only one trim potentiometer on the board. On its surface are five transistors of two sorts. Each transistor is clearly labeled. Carbon composite resistors and ceramic and aluminum electrolytic capacitors are used on the board. The diodes are labeled. On the board, there is only one integrated circuit. A single line of metal pins is attached to one side of the card. These pins will be linked into the Speedtronic system as a communication device.

Features 

▪ Contains 10 Mbytes of battery-backed user memory and 10 Mbytes of non-volatile flash user  memory. 

▪ Provides access to bulk memory via reference table %W. 

▪ Configurable data and program memory. 

▪ Programming in Ladder Diagram, C, Structured Text, and Function Block Diagram. 

▪ Supports auto-located Symbolic Variables that can use any amount of user memory. 

▪ Reference table sizes include 32Kbits for discrete %I and %Q and up to 32K words each for  analog %AI and %AQ. 

▪ Supports Series 90-70 discrete and analog I/O, communications, and other modules. For a  list of modules supported, refer to the PACSystems RX7i Installation Manual, GFK-2223. 

▪ Supports all VME modules supported by Series 90-70. 

▪ Supports RX7i data monitoring over the web. Allows a combined total of up to 16 web server  and FTP connections. ▪ Supports up to 512 program blocks. Maximum size for a block is 128KB. 

▪ Test Edit mode allows you to easily test modifications to a running program. 

▪ Bit-in-word referencing. 

▪ Battery-backed calendar clock. 

▪ In-system upgradeable firmware. 

▪ Three isolated serial ports: an RS-485 serial port, an RS-232 serial port, and an RS-232  Ethernet station manager serial port. 

▪ The embedded Ethernet interface provides: 

 Data exchange using Ethernet Global Data (EGD) 

 TCP/IP communication services using SRTP 

 Support for SRTP Channels, Modbus/TCP Server, and Modbus/TCP Client 

 Full programming and configuration services 

 Comprehensive station management and diagnostic tools 

 Two full-duplex 10BaseT/100BaseT/TX (RJ-45 Connector) ports with an internal network  switch providing auto-negotiated network speed, duplex mode, and crossover detection. 

 User-configurable Redundant IP address 

 Time synchronization to SNTP time server on Ethernet network (when used with  Release 5.00 or later CPU module).