GE Mark VI | IS200VTURH1B | Primary Turbine Protection Board

GE Mark VI | IS200VTURH1B | Primary Turbine Protection Board

Board Number:IS200VTURH1BAC Series:Mark VI Manufacturer:GE Industrial Systems, General Electric Company Functional Acronym:VTUR Model Type:Protection Board Supported Components:VTUR TRPG, TRPL, TREG, TRPS MPU Pulse Rate Range:2 Hz to 20 kHz MPU Pulse Rate Accuracy:0.05% of Reading Number of Trip Solenoids:3 Contact Voltage Sensing:20 V dc for HI and 6 V dc for LO Engineered with advanced triple modular redundant (TMR) architecture for unparalleled reliability and redundancy, the IS200VTURH1B ensures continuous operation and minimal downtime. 

 Featuring an integrated human-machine interface (HMI), this board enables real-time monitoring and control of turbine operations, enhancing operational efficiency and safety. Designed to monitor critical parameters such as induced shaft current/voltage, with alarms for excessive levels, this board provides proactive maintenance alerts, minimizing unexpected failures. The board is compatible with the GE Mark VI system  suite of modules, including TRPG, TRPL, TREG, and TRPS, offering seamless integration and comprehensive turbine protection. Crafted from high-grade materials, the IS200VTURH1B withstands harsh industrial environments, ensuring durability and long-lasting performance in challenging conditions. The IS200VTURH1B Primary Turbine Protection Board, by GE, safeguards gas/steam turbines in industrial settings, ensuring reliable operation through advanced monitoring and control mechanisms. 

Compatibility 

ƒ Compatible with any Series 90-30 CPU except IC693CPU321 and IC693CPU340. Configuration size is limited for CPU311/313/331, as described on the next page. 

ƒ Requires release 8.0 CPU firmware. The latest Release 10 is recommended, if available for the particular CPU. 

ƒ Requires CIMPLICITY Machine Edition Logic Developer PLC version 3.0 plus the appropriate service pack or special (or a version later than 3.0). 

ƒ Not compatible with the VersaPro™, Control, or Logicmaster™ programming software. 

ƒ The Series 90-30 Hand-Held Programmer (IC693PRG300) cannot be used to configure this module. New Features The Series 90-30 DeviceNet Master Module allows a Series 90-30 PLC to send and receive I/O data from a DeviceNet network. 

Module features include: 

ƒ Support for all standard data rates (125K, 250K, 500K) 

ƒ Support for 255 bytes input data transfer and 255 bytes output data transfer per slave 

ƒ Support for 3972 bytes of input data transfer and 3972 bytes of output data transfer per master 

ƒ Support for two I/O connections per Slave - Typically one connection is used for Polled and the other is used for Strobe, Cyclic, or COS 

ƒ Support for Poll, Strobe, Cyclic and COS I/O Connections, Fragmented I/O and Explicit Messaging 

ƒ Support for Unconnected Message Manager (UCMM) with 1 proxy connection per slave device 

ƒ Support for configuration of the global scan rate 

ƒ Support for configuration of update rates for Poll and COS/Cyclic on a connection basis 

ƒ Support for PLC-application initiated explicit messaging via a COMMREQ 

ƒ Master can be configured to operate as a slave simultaneously with master operation 

ƒ Configurable fault behavior on loss of communication 

ƒ Reports loss or reestablishment of communication with slaves in PLC fault table (configurable) 

ƒ Support for 64 network device status bits (note: the bit for the master itself is always zero) 

ƒ Firmware update via service port on module