GE DS200TCQFG1A Analog I/O Extension Card

GE DS200TCQFG1A Analog I/O Extension Card

Part Number DS200TCQFG1A Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark V Function Module Availability In StockDS200TCQFG1A is a TC2000 Analog I/O Extender Board manufactured by General Electric as part of the Mark V series used in gas turbine control systems. Seven jumpers and two 50-pin connectors are present on it. A 9-pin connector and a 34-pin connector are also included. 

The 34-pin connector has the ID JA given to it. The 50-pin connectors have the IDs JUU and JB allocated to them. Electronic relays are used by the GE TC2000 Analog I/O Extender Board to turn circuits on and off during routine processing. The relays are present on the board and have wire leads soldered to them. Additionally, there are 6 LEDs on the board, which are positioned horizontally. When the board is mounted in the board cabinet inside the drive, the operator can see them. 

When illuminated, the LEDs are green and function as expected. In other words, when the LEDs are lighted, it means that the function they stand for is getting power and functioning normally. The board's six LEDs are connected to various circuits and functions. The LEDs flashing means that regular processing is happening. This gives the operator a simple way to assess the board's condition while the drive is running. A programmable logic device that performs a processing function required for the TC2000 Analog I/O Extender Board's proper operation is installed on the board. The erasable programmable read-only memory (EPROM) module installed on the board is used by the programmable logic to store firmware and programming code.

OTHER INFORMATION

• Available with either the 1.1 GHz, 1.6 GHz or 1.8 GHz  Pentium® M processor  

• 1.4 GHz Pentium M processor coming soon  

• Up to 2 Mbyte of advanced L2 cache  

• Up to 1.5 Gbyte DDR SDRAM  

• Up to 2 Gbyte bootable CompactFlash on secondary IDE (see  ordering options)  

• Internal SVGA and DVI controller  

• Serial ATA support through P2 rear I/O  

• 400 MHz system bus via Intel® 855GME chipset  

• Ethernet controller supporting 10BaseT and 100BaseTX  through the front panel  

• Gigabit Ethernet controller supporting 10BaseT, 100BaseTX  and 1000BaseT interface with optional VITA 31.1 support  

• Four asynchronous 16550 compatible serial ports  

• Four Universal Serial Bus (USB) Rev. 2.0 connections, two on  the front panel and two rear I/O  

• PMC expansion site (PCI-X, 66 MHz)  

• 32 Kbyte of nonvolatile SRAM  

• Operating system support for Windows® XP, Windows 2000,  VxWorks®, QNX® , LynxOS® and Linux

Instructions and warnings related to the operation of the product:

The following specifications must be strictly observed:

 The technical specifications and typical applications of the product system must be strictly observed.

 PERSONNEL TRAINING: Only trained personnel may install, operate, maintain or repair the product system. These personnel must be instructed on the

These personnel must be instructed and briefed on the conditions in the hazardous area.

 Unauthorised modifications: No modifications or structural changes may be made to the product system.

 Maintenance Responsibility: It must be ensured that the product system is used only under appropriate conditions and in a condition fully suitable for use.

 Working environment: The user must fulfil the specified environmental conditions:

Safety regulations

The following safety regulations must be fully observed when (maintenance) work is carried out on the product system:

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Confirm that the installation has been completed.

4 Perform grounding and short-circuiting.