GE IC693PWR322J POWER SUPPLY High-Performance Power Solution for Industrial Automation

IC693PWR322J POWER SUPPLY  High-Performance Power Solution for Industrial Automation

Model:IC693PWR322J Brand:GE Rated Output Voltage:24VDC Maximum Load Current:5A Efficiency:96% Input Voltage Range:100-240VAC Operating Temperature:-10"C to +55"C Humidity Range:5% to 95% RH non-condensing Certifications:CE, UL, CSA Engineered for Extreme Durability The GE IC693PWR322J is built to withstand the rigors of industrial settings, ensuring continuous operation under varying environmental conditions. 

 Efficient Power Management This power supply is designed with advanced circuitry to optimize energy usage, reducing operational costs and environmental impact. Versatile Compatibility It seamlessly integrates with a wide range of GE and third-party industrial control systems, facilitating easy installation and maintenance. Ease of Installation With its compact size and user-friendly design, the IC693PWR322J simplifies the setup process, saving valuable time and resources. Advanced Protection Features The device incorporates overvoltage protection and short-circuit protection mechanisms, safeguarding against potential damage and enhancing system uptime. The GE IC693PWR322J Power Supply is an essential component in industrial control systems, designed to provide reliable power for PLCs and other electronic devices, ensuring seamless operation in diverse industrial environments. 

Features 

 Single-Slot Module 

 SNP/SNP-X Protocol (master, slave) 

 CCM Protocol (master, slave, peer) 

 RTU Modbus Protocol (slave only) 

 Supports connection to MS-DOS or Windows

 programming and configuration software package (monitor only) 

 12 Mhz, 80C186 Microprocessor 

 Two RS-422/RS-485 or RS-232 Serial Ports 

 CCM, RTU and SNP/SNP-X Available on Either or Both Ports 

 Simultaneous Communications on Both Ports (up to 9.6 Kbps, or 19.2 Kbps individually) 

 High Performance Access to PLC Memory 

 Three Status LEDs 

 Reset pushbutton 

 Soft Switch Configuration (no switches or jumpers) 

 No Battery Required

Ease of Use

• Simple and powerful instruction set 

• One-axis or two-axis motion programs with synchronized block start 

• Program support for a short motion program (called Program Zero) which can be created in the MS-DOS programming software configuration function 

• Nonvolatile (flash) storage for 10 programs and 40 subroutines 

• User scaling of programming units (in Standard mode only) 

• Generic programming using command parameters as operands for Acceleration, Velocity, Move and Dwell commands 

• Configured with MS-DOS configuration software