GE FANUC 151X Gas Turbine Control System, Advanced Technology for Industrial Applications

GE FANUC 151X Gas Turbine Control System, Advanced Technology for Industrial Applications

Series:Mark VI Model Number:151X1235DB15SA01 Power Supply Voltage:48V DC Operating Temperature Range:-20"C to +55"C Memory Capacity:1MB Communication Protocol:Modbus TCP/IP, OPC-UA Redundancy:Redundant CPU design Certifications:CE, UL, ISO 9001 The GE FANUC 151X Gas Turbine Control System is designed with cutting-edge technology to optimize performance and reduce maintenance needs. Its robust design ensures seamless integration into various gas turbine operations, enhancing safety and productivity. Equipped with a comprehensive set of communication protocols, this system supports a wide range of automation tasks, facilitating smooth interaction with other industrial systems. Its modular architecture allows for flexible customization to meet specific application requirements. 

 Featuring a memory capacity of 1MB, the system can store extensive data for monitoring and analysis, enabling operators to make informed decisions based on real-time performance metrics. The built-in redundancy mechanism ensures continuous operation even in case of component failures, minimizing downtime. With its compact size and efficient power consumption, the GE FANUC 151X is ideal for space-constrained environments. It has been rigorously tested and certified to meet international standards, ensuring reliability and safety in industrial settings. Designed with ease-of-use in mind, the system offers intuitive setup and maintenance procedures, reducing the learning curve for technicians and operators. Comprehensive documentation and support are provided to facilitate quick adoption and optimal system performance. The GE FANUC 151X Gas Turbine Control Systems are engineered to deliver precise and reliable control solutions for complex industrial applications, ensuring optimal performance and efficiency in power generation.

Compatibility 

ƒ Compatible with any Series 90-30 CPU except IC693CPU321 and IC693CPU340. Configuration size is limited for CPU311/313/331, as described on the next page. 

ƒ Requires release 8.0 CPU firmware. The latest Release 10 is recommended, if available for the particular CPU. 

ƒ Requires CIMPLICITY Machine Edition Logic Developer PLC version 3.0 plus the appropriate service pack or special (or a version later than 3.0). 

ƒ Not compatible with the VersaPro™, Control, or Logicmaster™ programming software. 

ƒ The Series 90-30 Hand-Held Programmer (IC693PRG300) cannot be used to configure this module. New Features The Series 90-30 DeviceNet Master Module allows a Series 90-30 PLC to send and receive I/O data from a DeviceNet network. 

Module features include: 

ƒ Support for all standard data rates (125K, 250K, 500K) 

ƒ Support for 255 bytes input data transfer and 255 bytes output data transfer per slave 

ƒ Support for 3972 bytes of input data transfer and 3972 bytes of output data transfer per master 

ƒ Support for two I/O connections per Slave - Typically one connection is used for Polled and the other is used for Strobe, Cyclic, or COS 

ƒ Support for Poll, Strobe, Cyclic and COS I/O Connections, Fragmented I/O and Explicit Messaging 

ƒ Support for Unconnected Message Manager (UCMM) with 1 proxy connection per slave device 

ƒ Support for configuration of the global scan rate 

ƒ Support for configuration of update rates for Poll and COS/Cyclic on a connection basis 

ƒ Support for PLC-application initiated explicit messaging via a COMMREQ 

ƒ Master can be configured to operate as a slave simultaneously with master operation 

ƒ Configurable fault behavior on loss of communication 

ƒ Reports loss or reestablishment of communication with slaves in PLC fault table (configurable) 

ƒ Support for 64 network device status bits (note: the bit for the master itself is always zero) 

ƒ Firmware update via service port on module