GE DS200PTCTG2B Signal Conditioner Board

GE DS200PTCTG2B Signal Conditioner Board

Part Number DS200PTCTG2B Manufacturer General Electric Country of Manufacture As Per GE Manufacturing Policy Series Mark V Function Module Availability In StockDS200PTCTG2B is a Signal Conditioner Board and a part of the GE Mark V series used in gas turbine control systems. DS200PTCTG2B comes with a single terminal block with 72 signal wire terminals. One 50-pin connector is also included. OUT2, OUT1, COM1, COM2, P15, SO21, and L23 are the IDs for the terminals on the terminal block. There are additional termination posts for six signal cables. 

When the GE Speedtronic Signal Conditioner Board is put in the drive, it has the ability to connect to various signal wires and ribbon cables. Some signal cables carry signals from the board to the drive's other boards for processing. Signals are sent to the board for processing via other signal lines. After that, the signals are transferred to other boards to be processed further. Because there are so many wires, it's crucial to remember that air must circulate freely inside the drive, and the cables must be routed so that they don't obstruct it. Cool air enters the drive from the bottom and flows around, over, and under the heat-generating components when the drive is in operation. 

The processing boards that send and receive signals are among these components. The motor and its accompanying moving elements are also included. The interior of the drive may become overly hot if the air is trapped by wire bundles. This would result in an overheating problem, causing the drive to shut down automatically. Keep the wires away from the air vents and route them along the sides of the drive interior to avoid an overheating situation.

OTHER INFORMATION

• Available with either the 1.1 GHz, 1.6 GHz or 1.8 GHz  Pentium® M processor  

• 1.4 GHz Pentium M processor coming soon  

• Up to 2 Mbyte of advanced L2 cache  

• Up to 1.5 Gbyte DDR SDRAM  

• Up to 2 Gbyte bootable CompactFlash on secondary IDE (see  ordering options)  

• Internal SVGA and DVI controller  

• Serial ATA support through P2 rear I/O  

• 400 MHz system bus via Intel® 855GME chipset  

• Ethernet controller supporting 10BaseT and 100BaseTX  through the front panel  

• Gigabit Ethernet controller supporting 10BaseT, 100BaseTX  and 1000BaseT interface with optional VITA 31.1 support  

• Four asynchronous 16550 compatible serial ports  

• Four Universal Serial Bus (USB) Rev. 2.0 connections, two on  the front panel and two rear I/O  

• PMC expansion site (PCI-X, 66 MHz)  

• 32 Kbyte of nonvolatile SRAM  

• Operating system support for Windows® XP, Windows 2000,  VxWorks®, QNX® , LynxOS® and Linux

Instructions and warnings related to the operation of the product:

The following specifications must be strictly observed:

 The technical specifications and typical applications of the product system must be strictly observed.

 PERSONNEL TRAINING: Only trained personnel may install, operate, maintain or repair the product system. These personnel must be instructed on the

These personnel must be instructed and briefed on the conditions in the hazardous area.

 Unauthorised modifications: No modifications or structural changes may be made to the product system.

 Maintenance Responsibility: It must be ensured that the product system is used only under appropriate conditions and in a condition fully suitable for use.

 Working environment: The user must fulfil the specified environmental conditions:

Safety regulations

The following safety regulations must be fully observed when (maintenance) work is carried out on the product system:

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Confirm that the installation has been completed.

4 Perform grounding and short-circuiting.