GE IC690USB901 Programmable Logic Controller Programming Cable

IC690USB901 Programmable Logic Controller Programming Cable

Connectivity Type:USB 2.0 Interface Protocol:RS232 Communication Speed:Up to 115,200 bps Power Source:Self-powered via USB port Compatibility:GE PLC models including IC690 series Length:Standard 3-meter length The GE IC690USB901 is specifically designed for use with the GE IC690 series programmable logic controllers (PLCs), providing a reliable and cost-effective solution for programming and diagnostics tasks. This USB cable ensures high-speed data transfer, enabling users to efficiently program their PLCs without the need for specialized interfaces or additional hardware. 

 With its rugged design and wide temperature range compatibility, the GE IC690USB901 is suitable for various industrial environments, ensuring durability and reliability in challenging conditions. Installation and setup are straightforward, requiring no complex configurations or software installations, making it accessible for technicians and engineers of all skill levels. Compliance with international safety standards ensures that the GE IC690USB901 meets industry requirements, providing peace of mind and enhancing the overall performance of your automation systems. The GE IC690USB901 PLC Programming Cable enables seamless communication between your computer and the GE IC690 series PLCs via USB, facilitating efficient programming, diagnostics, and configuration.

Compatibility 

ƒ Compatible with any Series 90-30 CPU except IC693CPU321 and IC693CPU340. Configuration size is limited for CPU311/313/331, as described on the next page. 

ƒ Requires release 8.0 CPU firmware. The latest Release 10 is recommended, if available for the particular CPU. 

ƒ Requires CIMPLICITY Machine Edition Logic Developer PLC version 3.0 plus the appropriate service pack or special (or a version later than 3.0). 

ƒ Not compatible with the VersaPro™, Control, or Logicmaster™ programming software. 

ƒ The Series 90-30 Hand-Held Programmer (IC693PRG300) cannot be used to configure this module. New Features The Series 90-30 DeviceNet Master Module allows a Series 90-30 PLC to send and receive I/O data from a DeviceNet network. 

Module features include: 

ƒ Support for all standard data rates (125K, 250K, 500K) 

ƒ Support for 255 bytes input data transfer and 255 bytes output data transfer per slave 

ƒ Support for 3972 bytes of input data transfer and 3972 bytes of output data transfer per master 

ƒ Support for two I/O connections per Slave - Typically one connection is used for Polled and the other is used for Strobe, Cyclic, or COS 

ƒ Support for Poll, Strobe, Cyclic and COS I/O Connections, Fragmented I/O and Explicit Messaging 

ƒ Support for Unconnected Message Manager (UCMM) with 1 proxy connection per slave device 

ƒ Support for configuration of the global scan rate 

ƒ Support for configuration of update rates for Poll and COS/Cyclic on a connection basis 

ƒ Support for PLC-application initiated explicit messaging via a COMMREQ 

ƒ Master can be configured to operate as a slave simultaneously with master operation 

ƒ Configurable fault behavior on loss of communication 

ƒ Reports loss or reestablishment of communication with slaves in PLC fault table (configurable) 

ƒ Support for 64 network device status bits (note: the bit for the master itself is always zero) 

ƒ Firmware update via service port on module